Misc. Units

[ Home ] [ Up ] [ News ] [ Services ] [ Distributors ] [ Harness Use List ] [ Feedback ] [ Literature Request ]

Table of Contents

CONTACT
  INFORMATION:
  LinAire Engineering 
                                                       LinAire 
DISTRIBUTORS

  Search Web Site

Misc. Units

    CONTROL HEADS:

        LinAire control heads mount in their respective LinAire test panels only.

       LTC-6    Provides 2x5 and King BCD parallel tuning for the LT test panel.
                        The 2x5 tunes from 116.00 to 151.975 MHz.
                        The King BCD tunes from 118.00 to 135.975 MHz.
                        The LTC6 cost is CALL

        LVC-6    Provides 2x5 and BCD parallel tuning for the LV test panel.
                         Tunes from 108.00 to 117.975 MHz.
                         The LVC6 cost is CALL

    STAND ALONE TESTER:

        LTS-120    Tests the King KA-120.  Just add power and serial signals.

        JT-2            Transponder Encoding Tester.   

        The answer to C-MODE ENCODER and C-MODE TRANSPONDER TROUBLESHOOTING, BOTH in the Aircraft and ON THE BENCH.

        No more time consuming diagnostics using Prints, Continuity Meters, DVM's and Wasted Man-hours.  Just plug the JT2 in and localize the problem - right away - right in the aircraft.  When used with a Transponder Ramp Tester it checks Transponder C-MODE operation, the Installation, and by substitution, the condition of the C-MODE Encoder.  This unit makes Encoder, Installation and Transponder checks so simple and fast that it pays for itself with one use.
        Every technician will want their own JT 2 once they discover the remarkable utility of this unit.
        This handy little unit is only 5.5 inches wide, 2.625 inches deep and 1.625 inches high.
        Fits anywhere, and takes up less room than an Encoder.
        Unit features:  
        Tip Jacks to check the status of all C-MODE data line levels and power to the Encoder.
        Push-buttons to pull data lines low and Encode the Transponder thus checking
            Transponder and Installation.
        Encoder power lamp to indicate power to the Encoder and a Heater Press to Test to check
            the presence of Heater ground.

        The JT 2 plugs in directly in place of the following Encoders:

        ACK        Ameri-King        Bendix/King        Green        II Morrow        NARCO        Trans-Cal
        United Industries        Terra

        With ADAPTERS:        Aero Mec        Aero Sonic        Bendix        Kollsman        MAC       
                                                 Smith Industries

        Adapters available for LinAire LA 6 panel and LX9100 series Transponder Test Cables.

        Extender cables available for those places where a little more room is needed.

                            JT-2 Harness list follows:

  Avionics Test Equipment Panels and Cables for bench testing of Aircraft Radio, Navigation, Audio Controllers, Radar and more. Linaire Engineering Inc.
Last modified: June 15, 2004