Inverters

[ Home ] [ Up ] [ News ] [ Services ] [ Distributors ] [ Harness Use List ] [ Feedback ] [ Literature Request ]

Table of Contents

CONTACT
  INFORMATION:
  LinAire Engineering 
                                                       LinAire 
DISTRIBUTORS

  Search Web Site

    LI-2 & LI-3 INVERTER TEST PANEL

                   
                    LI - 2 / LI - 3

    The Inverter Test panel is a resistor load bank with input and output metering.
  
    Input voltage (0 - 30 DC) and (0 - 100 Amp) input current are metered on the panel.  The DC input power is protected by a 50 Amp circuit breaker.  The power is connected to the inverter through a 3 pin  connecter and controlled by the panel ON/OFF switch which operates a high current relay.

    The load bank is fan cooled.  Both the fan and relay operate at either 115V AC (LI3) or  230V AC (LI2) 50-60 Hz. 

    The inverter's output voltage and current for both 26VAC and 115VAC 400Hz are metered on the panel.  There are 5 loads (175VA each) selectable for the 115VAC and 1 load(70VA) for the 26VAC inverter outputs.  The outputs are circuit breaker protected.

    Tip Jacks allow for scope connection to view the waveform.

    The panel is a completely cabinet enclosed unit. The panel can be used as a stand-alone unit or rack-mounted.  The panel is 19" wide, 8.75" high, and 6" deep(rack-mouted).

    The panel has numerous test harnesses available.
     LI 2 / 3

    AVIONICS INSTRUMENTS        FLITE-TRONICS        KSG ELECTRONICS        LELAND

    LI-3 INVERTER TEST PANEL,  (115volts)                         PRICE: CALL

  Avionics Test Equipment Panels and Cables for bench testing of Aircraft Radio, Navigation, Audio Controllers, Radar and more. Linaire Engineering Inc.
Last modified: June 15, 2004